I got clear film fitted on my black Lexus RX about ten months ago, and over the last few weeks I started noticing that the edges on the front doors are curling up a little. It is not much, but when I run my finger along the corner I can feel it lift, and last night I saw a thin line of dust sitting right under it. I was annoyed, because I paid for a full front kit and the shop promised it would last for years. My brother says peeling always means the installer rushed the job and did not wrap the edges properly. My neighbor says the sun here is brutal and that every film starts to lift somewhere after a hot summer, so I should not expect miracles. A friend at work told me that a door edge peels easily if the car is washed with a pressure jet too close to the corner. Another colleague said that if the panel was not cleaned properly before the film went on, the glue never grips well and the edge lets go first. I read a page on last night to understand why film peels, and it explained how heat, poor prep, stretched corners and rough washing can each play a part, which made me realise I cannot blame one thing without checking. Since then I have been searching for Reliable fixes for peeling PPF edges, because I want to know if a small peel can be repaired or if the whole panel has to be redone. My questions are easy. Does the warranty usually cover peeling after ten months, or only the first few weeks? Can a shop heat and press the edge back, or does it come off again? Is it a bad idea to trim the loose bit with a blade at home? And if dust is already under the edge, should I worry about marks on the paint? Please share what happened with your car. Thanks for reading.